Special Functions Menu; Enter In The Special Functions Menu; Diagnostic Sensors Menu; Statistic Menu - Fasep B140.G2.T Manuel De L'utilisateur

Fasep 2000 srl
Balatron B140.G2.TC: User's Manual
8

SPECIAL FUNCTIONS MENU

8.1

Enter in the special functions menu

Switch on the wheel balancer and press <SET> before SOF X.XX will disappear.
The possible functions are:
CAL
Calibration of wheel balancer
CAL tSt Control of the calibration of electronic sensors
CAL rod Calibration of electronic input sensors
SEn Sor Diagnostic of sensors
StA tiS Statistic about the use of machine
USr Set User setup
tEc Set Technical Setup
Ser nuM Serial number
Act Cod Inserting Activation Codes
8.2

Diagnostic sensors menu

Switch on the wheel balancer and press <SET> before SOF X.XX will disappear. Select Sen Sor and press <SET> to enter
in the diagnostic sensors menu.
The possible functions are:
rPM
Balancing speed
dIS
Value of distance sensor
dIA
Value of diameter sensor
tO
Encoder is in the zero position
PoS
Angle of position sensor(from 0 to 255)
PS1
Voltage of PS1
PS2
Voltage of PS2
Cou
Safety cover is open or closed
8.3

Statistic menu

Switch on the wheel balancer and press <SET> before SOF X.XX will disappear. Select Sta tis and press <SET> to enter
in the statistic menu.
The possible functions are:
tOt
SUC
from 11 to 17
CAL
8.4

User Setup

Switch on the wheel balancer and press <SET> before SOF X.XX will disappear. Select USa SET and press <SET> to enter
in the user setup menu.
The possible functions are:
ScA LE Set 1 or 5 grams step (0.05/0.25 onces)
Cut oFF Set minimum weight to be displayed
Uni Out Unit of measure for the width (0=inch, 1=millimeters)
Uni Umb Unit of measure for the weight (0= grams, 1=once)
Fin AL Display of final (0 = normal, 1 = blink, 2= Go OD).
biP
Acoustic signal (ON or OFF)
EME StP Motor brakes In case of emergency stop (On or OFF) (OFF: motor power is cut)
Cou Er On = the motor start only if the safety cover is closed;
OFF = safety cover is not installed;
Aut = closing of safety cover the motor starts automatically.
rod
Enable/Disable automatic input system
rES Et Load Factory Setup
Total number of spin
Percent of runs with a good result
Percent of wheels with the indicated diameter
Number of calibrations
9-1
Rev. 1.3
01 June 2013