Detecting And Correction Of The Umbalance - Fasep B140.G2.T Manuel De L'utilisateur

Fasep 2000 srl
Balatron B140.G2.TC: User's Manual
5.4

Detecting and correction of the umbalance

After setting wheel dimensions, spin the wheel till GOOD appears on the display.
5.4.1
G
GOOD = correct speed
NOTE:
ACCEL = accelerate (speed is too low)
DECEL = decelerate (speed is too high).
5.4.2 At the end of the spin, stop the wheel. The display will show the weight position and weight requirement to correct the wheel's
umbalance.
5.4.3 If umbalance shown is 0, press <FINE> to show residual umbalance.
F . 23: inside weight indication
IG
G
NOTE: OPT light blinking after the measurement indicates that static umbalance is exceeding more than 200grs.
Optimization procedure is suggested.
F . 24: outside weight indication
IG
6-1
Rev. 1.3
01 June 2013