Electromagnetic Compatibility; Cable Length; Recommended Separation Distances - Ultradent Products ultrawave XS Manuel D'utilisation

5 Electromagnetic compatibility

All the information below is based on the requirements of standards to which the manufacturers of
electrical medical devices must adhere (as stated in standard IEC60601-1-2).
The medical device complies with the electromagnetic compatibility standards in force. However, the user will make
sure that any electromagnetic interference does not create an additional risk, such as radiofrequency transmitters, or
other electronic devices.
This chapter contains the information required for you to install and use your medical device in optimum
conditions in terms of electromagnetic compatibility.
The different medical device cords must be kept away from each other.
Some types of mobile telecommunication devices such as mobile phones may interfere with the medical
device. The separation distances recommended in this chapter MUST be complied with.
The medical device must not be used near another device or placed on top of it. If this cannot be avoided, correct
operation of the device in operating conditions must be checked prior to use.
The use of accessories other than those specified or sold by SATELEC® or Ultradent Products Inc. as
replacement parts, may increase the transmission or reduce the immunity of the medical device.

5.1 Cable length

Cables and accessories
Cables/Cords

5.2 Recommended separation distances

The medical device is designed to be used in an electromagnetic environment in which interferences caused by RF
radiation are controlled.
Maximum length
RF emission
Harmonic current emission
Voltage fluctuation and
flickers
Electrostatic discharge
immunity
Radiated immunity –
Electromagnetic fields
Electrical fast
transient/burst immunity
< 3m
Surge immunity
Immunity to conducted
disturbances, induced by
radio-frequency fields
Radiated immunity - Manetic
fields
Voltage dips, short
interruptions and voltage
variation immunity
J00039 • V3 • (13) • 12/2013 • RB77US030D
Test type In compliance with:
CISPR 11, Class B
IEC61000-3-2
IEC61000-3-3
IEC61000-4-2
IEC61000-4-3
IEC61000-4-4
IEC61000-4-5
IEC61000-4-6
IEC61000-4-8
IEC 61000-4-11
9