EUROM 1809 Manuel D'instruction page 19

Operating principle
By moving the pump handle up and down, the liquid is pumped from the container
to the pump housing where pressure is created. By subsequently squeezing the
operating handle, the liquid is released via the nozzle.
Operating instruction
Remove all the packaging material and keep it out of reach of children. Check that
all the parts are present. Screw the lance onto the operating handle. Select a
nozzle and screw it on top of the lance.
Unscrew the cover of the container and slowly pour the liquid, including the
dissolved pesticide, into the container
through the filter. Subsequently, close the
cover tightly and put the device on to your
back. Create pressure by swinging the
pump handle. You can now start spraying
by squeezing the operating handle of the
jet lance. You can opt for continuous
spraying or spray a little bit directly on a
certain spot for a short time. By sliding the
red slide on the handle backwards, you can
lock the handle for uninterrupted spraying.
Select a nozzle that is suitable for the job at
hand. The device is supplied including
four different nozzles:
1. Flat jet nozzle
2. Single atomization nozzle
3. Double atomization nozzle
4. 4-holes nozzle
A spray cap is also included.
Flat jet nozzle:
Sprays uniformly and is suitable for spraying
low-growing, short and creeping crops and
for spraying pesticides. Hold the jet lance
steady and spray in the same direction as
the wind is blowing. You can use the spray
cap with this nozzle.
Single atomization nozzle and double
atomization nozzle:
Are suitable for spraying pesticides (against
diseases) and insect repellents. Spray in the
same direction as the wind is blowing!
19