Cleaning And Maintenance - Morphy Richards 47080 Manuel D'instructions

47080MEE-Rev3:Ion 441375253 Rev 1
C
D
E
6
21/1/08
To brew at a pre-set
time
C
• Press the PROGRAM button.
Note: If no buttons are pressed, the
display will revert to the time
display within 10 seconds.
• Press the HOUR button.
• Then press the MINUTE button to
set the desired start time.
To set to brew at a
pre-set time
D
• Press the AUTO button (green light
glows).
Note: Press the AUTO button again
to cancel pre-set brewing.
To brew manually
• Press the ON/OFF button (red light
glows).
Note: Press the ON/OFF button
again to cancel brewing.
CLEANING AND
MAINTENANCE
Locating the filter
1 To remove the filter holder, lift by
using the two handles either side to
clean. (See cleaning).
2 To refit, place the removable filter
holder into the top of your coffee
maker. Ensure that the cut out on
the filter holder lines up with the
slot at the back of the product.
3 Then place the permanent mesh
filter inside the filter holder.
Descaling
• If you live in a harder water area, we
recommend that your coffee maker
is descaled at regular intervals, eg.
every 2 - 3 months. In areas of
moderately hard water you should
descale every 6 months.
www.morphyrichards.com
12:16 Page 6
• If the water filters through more
slowly than usual, it is a sign that
descaling is necessary.
• We recommend you to use
proprietary liquid descaler which is
especially made for coffee makers
and plastic kettles. Follow the
instructions on the bottle or sachet,
and them operate the coffee maker
with just water 3 times before
making coffee.
• Do not use kettle descaler unless
the packet specially states it is
suitable for coffee makers.
NOTE: The permanent mesh filter
should not be used during
descaling.
Cleaning care
E Unplug The coffee maker, and allow
to cool.
Do not immerse the coffee maker in
liquid.
Rinse the water tank occasionally
with cold water. Do not use a cloth
as any residue or lint left behind
may clog the coffee maker.
Remove the permanent filter
discard used coffee and wash with
warm soapy water. Extended
soaking helps remove coffee stains
from the mesh. Rinse and dry
thoroughly.
Wipe all external surfaces with a
damp cloth and dry thoroughly.
Care must be taken to ensure the
non drip valve situated on the
bottom of the filter holder is not
damaged during cleaning.
Never use harsh or abrasive
cleaners.
IMPORTANT:
DO NOT WASH ANY OF THE
PARTS IN A DISHWASHER.