Beko CEG5301X Mode D'emploi page 26

6 Troubleshooting
Problem
The appliance does not work.
No or delayed response in
several trials of pressing on
function key on the panel
The coffee is not hot enough.
The coffee cannot come out
from spout.
The first cup of coffee is poor
quality.
Coffee has no cream.
The touch buttons are not
sensitive
The water tank is removed
/ the water level is very
low in the water tank but
have no alert.
Internal drip tray is filled with a
lot of water.
Coffee is delivered too slowly
or a drop at a time.
Lack of bean indicator flashes
but there is still a lot of coffee
bean inside the container.
26 / EN
Cause
The appliance is not connected
to the mains.
Appliance is under
electromagnetic interference
Dirt over the panel
The cups have not been
preheated.
The brewing unit is too cold.
Empty system function maybe
used before.
The first run of grinder does
not pour sufficient quantity
coffee power into the brewing
unit.
Not pressing the touch
button from the front
direction of the appliance
Excessive scale has built
up.
The area near the water
tank connector is wet.
Coffee powder too fine which
block the water to come out.
Coffee powder too fine which
block the water to come out.
Internal coffee powder outlet
is blocked.
Fully Automatic Coffee Maker / User Manual
Solution
Plug in and press the switch.
Check the cable and the Plug
an Unplug the appliance. Restart
after few minutes
Clean the panel with the cloth
provided
Rinse the appliance at least
3 times before making the
coffee.
Press the hot water button
until water can come out from
spout.
Throw the coffee away. The
other coffees will always be of
good quality.
Press the lower bottom part of
the icon of
the touch button from the
front direction of the appliance.
Descale the appliance.
Wipe the water around the
water tank
connector
Adjust the coffee fineness
to bigger dot during grinder
operation.
Adjust the coffee fineness
to bigger dot during grinder
operation.
To follow the steps of section
E (V. Cleaning coffee powder
outlet).