Installing And Removing The Battery Pack - Porter Cable PCC780 Manuel D'instructions

2. Turn the edge guide lock
Fig. J
Specifcations
Voltage
RPM
Depth of Cut
Blade Sizes
Arbor Size
OPERATION

WARNING: To reduce the risk of serious personal
injury, turn tool off and remove the battery pack
before transporting, making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury. Make sure the
switch is in the OFF position.

Installing and Removing the Battery Pack

(Fig. K)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
pack with the rails on the side of the tool and slide it into
the tool until the battery pack is firmly seated in the tool and
ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button and firmly pull the battery pack out of the tool.
25
Insert it into the charger as described in the charger section
of this manual.
Fig. K
24
8 clockwise to tighten.
8
7
20 V
2800
1.25" (32 mm)
7" (178 mm)
5/8" (16 mm)
24 into the tool, align the battery
25
Tool Placement (Fig. L)
Place saw on a stable, level surface.
Fig. L
9
On/Off Switch (Fig. M)
• To turn the wet tile saw on, lift up the on/off switch
• The wet tile saw locks on automatically.
• To turn the tool off, push the on/off switch down.
NOTE: A removable safety lock
unauthorized use.
Fig. M
26
Filling and Draining the Water Reservoir
(Fig. N)
1. Plug the water reservoir drain hole
drain plug
22
by tightening the attached wing nut
Figure N.
2. Slowly fill the water reservoir to the MIN fill line
prevent accidental overfilling. Do not fill above the MAX
fill line 31 . (Fig N)
3. To drain the reservoir, place a 5 gallon (19 liter) bucket
under the drain plug.
4. Remove the drain plug by loosening the attached wing
nut and allow the water to empty into the bucket.
26 . can be removed to deter
21
. Secure the drain plug into position
23
English
.
1
1
with the
as shown in
30 , to
9