Cleaning; Handling - Renkforce A-1200 Mode D'emploi

b) Cleaning
Before cleaning the device, separate it from the power supply and allow it to cool down.
The device is maintenance-free. Never try to open it. If you do open it, the warranty will be rendered void.
Only clean it with a soft, dry cloth or brush. Never use aggressive cleaning agents or chemical solutions as
the surface of the casing could be damaged.
You can clean the outside of the fog machine with a moistened cloth. Never use aggressive cleaning
agents, chemical solutions or scouring agents as the paintwork could be damaged.
To avoid deposits and residues in the fog fluid channels, use a special fog machine cleaner. Observe the
instructions for the cleaning liquid.

8. Handling

• Never connect the power plug immediately after the device has been taken from a cold to a warm envi-
ronment. The condensation generated could destroy the device.
Allow the device to reach room temperature before connecting it. Wait until the condensation water has
evaporated.
• Never pull on the power cable. Only unplug it by pulling on the plug.
• Unplug the power supply if you do not use the device over a period of time.
• For safety reasons, always pull the mains plug from the socket during a thunderstorm.
• Never touch the device around the fog outlet during or shortly after operation. This part of the device
becomes extremely hot. Risk of burns.
• Never use soiled fog liquid. Always close the tank and the fog liquid container immediately after filling.
• Always empty the tank before transporting the device or when it is not used for a longer period of time.
• Only use water-based fog liquids. Suitable fog liquids are listed in the „Specifications".
23