Maintenance; Fuse Replacement - Renkforce A-1200 Mode D'emploi

7. Maintenance

Check the technical safety of the fog machine regularly, e.g. for damage to the connection cables or to
the casing.
If you have reason to believe that the device can no longer be operated safely, disconnect it immediately
and make sure it is not unintentionally operated.
It can be assumed that safe operation is no longer possible if:
• the device, the remote control or the connection cables show visible damage
• the device no longer functions
• the device has been stored under unfavourable conditions for a longer period of time
• the device has been subjected to heavy transport strain
Always observe the following safety instructions before cleaning or servicing the device:
Live components may be exposed if covers are opened or parts are removed (unless these parts
are intended to be removed without tools).
Connection points may also be live.
If the device needs to be opened for calibration, servicing, repair or replacement of parts or
components, it must be disconnected from all voltage sources first.
Any necessary servicing or repair on the open device must be carried out by a specialist who is
familiar with the risks involved and the relevant regulations.
Capacitors inside the device may still carry voltage even though they have been disconnected
from all power sources.
a) Fuse Replacement
If it becomes necessary to replace a fuse, make sure that only fuses of the prescribed type and nominal
current are used (see „Technical Data").
Never repair fuses or bridge the fuse holder.
• After the device is disconnected from the mains (pull mains plug!), carefully remove the safety cap at the
fuse holder FUSE with the defective fuse by turning it with a suitable screwdriver.
• Remove the defective fuse and replace it with a fuse of the same type.
• Carefully screw the fuse cap with the new fuse back into the FUSE holder now.
• After this, you can reconnect the device to the mains and take it into operation.
22