840123300 ENv03.qxd 4/15/04 3:31 PM Page 4
How to Assemble and Use
Selecting the Proper Location
To prevent the risk of personal injury or damage to the product and
provide the best possible performance of your product, follow the
placement guidelines below:
DO:
• Place the product on a flat, stable
• Place product near an electrical outlet
where it is out of the way. Make sure
that the product and the cord do not
present tripping hazards.
• Select a central location with adequate
air circulation.
• Turn off and unplug product before
moving or servicing it, or if it will not
be used for several days.
• Route the electrical cord clear of
furniture to prevent damage from
pinching the cord.
Using the Product
1. Before First Use: Be sure to remove
all packing materials.
Replacing the Filter
1. Turn off the product and unplug from
outlet.
2. To remove intake grille, press on the
grille release buttons on each side of
the grille and pull outward from the
top of the grille.
4
DO NOT:
• Do not stand, sit, or place any objects
surface.
• Do not block air intake and outlet
grilles with drapes, curtains, or blinds.
This may cause reduced performance.
• Do not use in cooking areas, garage,
or areas with grease, oil or chemicals
such as solvents or insecticides.
• Do not place on or near heat sources
such as stoves, radiators, or heaters.
• To reduce electrical noise and
interference, do not place on or near,
or plug into the same outlet as TVs,
baby monitors, or cordless phones.
• Do not place in direct sunlight as the
plastic may discolor after prolonged
exposure.
2. See "Replacing the Filter" for disas-
sembly instructions.
3. Remove the used filter by gripping
the sides and pulling outward.
Discard the used filter. It cannot be
cleaned.
4. Remove any packing materials from
the new filter and install with the air-
flow arrow printed on the filter frame
pointing into the appliance.
(cont.)
on the prod-
uct. It is not
designed to
support addi-
tional weight.