Turn Off; General; Lance And Gun; Water Drain - Dibo 1D CPU-S Mode D'emploi

E N
T U R N O F F

Turn off

GENERAL

Put the operating switch on OFF when you finish the works.

LANCE AND GUN

Uncouple the lance and put it away. Close the water supply.
Roll up the high and low pressure hoses.

WATER DRAIN

See chapter "Safety – general warnings" on page 9

DISCONNECT MACHINE

Release the pressure of the hoses by means of pressing the lance. Consult a
DiBO technician for switching off the machine for a long time. This can take
the necessary measures for shutting down the machine for a long time without
damage.
ENVIRONMENTALLY SAFE DISPOSAL OF USED FLUIDS
No fluids (anti-scale product, oil, petrol, diesel, softener, ...) may be disposed
randomly because of the environment! So make sure, if you are user, that the
applicable local guidelines for environmentally friendly disposal of these fluids
(without soil pollution) are complied.

TRANSPORT

Pay attention at transport to the following: Keeps the machine as much as
possible horizontal during transport, one prevents that there leaks oil from the
pump. Load the machine using a lift truck, hydraulic loading platform or a hoist.
Lash the machines (if necessary) sound fixed on the loading platform.
Note after transport: always remove the red transport plug from the
high-pressure pump and mount the oil dipstick in the same place.

TRANSPORT AT FROST TEMPERATURES

Replace the water sucking hose by a short piece hose and hang it with his end
in the anti-frost, so the machine can suck the anti-frost.Take the lance from the
gun and operate the machine. Spray until anti-frost product flows from the spray
gun. The machine is now filled with anti-frost, stop the machine.
Tip: Because the catch of the outgoing anti-frost
water, this can be re-used afterwards.
DiBO 18