Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
User Options
Access Codes
Home > More > User Options > Access Code Prog [Master Code]
When Access Code Programming is selected from the User Options menu, the keypad prompts for a Master Code.
When a valid Master Code is entered, a numeric keypad is displayed with arrows to scroll to the desired user to add/
edit. Press the select button to enter the user options or enter the 2-digit user number to jump directly to a user.
Set Access Code – adds/edits the 4 or 6-digit code.
Prox Tag Programming – enrolls proximity tags (only available on WTK5504P).
User Options – enables/disables different options for the user.
Delete User – deletes the user from the system.
The access codes have programmable attributes which allow zone bypassing, remote access using the
ESCORT5580TC or one-time use activation.
Master Code (Access Code 40) - The master code, if programmed, can only be changed by the installer.
NOTE: The master code's attributes cannot be changed.
Supervisor Codes - These codes can be used to program additional codes which have equal or lesser attributes. Once
programmed, the supervisor codes receive the master code's attributes. These attributes are changeable. Any user code
can be made a supervisor code by enabling User Code Attribute 1 (please see below for details).
Duress Codes - Duress codes are standard user codes that transmit the Duress Reporting Code to the central station
when they are entered to perform any function on the system. Any user code can be made a duress code by enabling
User Code Attribute 2 (please see below for details).
NOTE: Duress codes are not valid when entering User Options, Master Functions or Installer's sections.
NOTE: Access codes cannot be programmed as a duplicate or as a "Code +/- 1". The keypad will notify you if a
duplicate code is entered. If a duplicate code is found, an error tone is given and the code is returned to what it was
before it was changed. This applies to both 4 and 6-digit codes.
User Code Attributes
1.
The default attributes of a new code will be the attributes of the code used to enter User Programming whether
it is a new code or an existing code being programmed.
2.
System Master Code 40 has attributes 3-4 ON by default.
NOTE: These attributes are not changeable.
Inherent Attributes (all codes except installer and maintenance)
Arm/Disarm - Any access code will be valid for arming and disarming that partition.
Command Outputs - If these outputs require access code entry, any Access Code will be valid for performing com-
mand output functions.
Programmable Attributes
1. Supervisor Code
2. Duress Code
3. Zone Bypassing Enabled
Bell Squawk Attribute
This attribute is used to determine whether an access code should generate an arming/disarming Bell Squawk upon
entry of the code for Away arming. The wireless keys with access codes associated with them may generate Arming/
Disarming Bell squawks. If desired, this option may be used with codes that are manually entered. Please contact your
installer to have this programmed.
NOTE: The Master Code cannot use the Bell Squawk attribute, but is required to enable it for other codes.
NOTE: This feature cannot prevent the Arming/Disarming squawks from being generated if an access code
assigned to a wireless key is manually entered at a keypad.
Figure 9 - User Options
4. Remote Access
5. Bell Squawk upon Arming/Disarming
6. One Time Use Code
8
Publicité
Table des Matières
