Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Setting Screen Saver Time-out
Home > More > User Options > Keypad Config > Brightness > Screen off
after X:XX:XX
You can use the slide bar to determine how long until the screen saver activates after the last button press. The screen
saver will either show the date and time or show a black screen, depending on how your installer configured the key-
pad. Valid values for this option are between 10 seconds and 10 minutes in 10 second steps. When this slider is in the
far left position, the screen saver is disabled and the screen will remain on.
1.
Use the slide bar to select the desired duration for the screen to remain active.
2.
To exit press the Back or Home button.
Verbal Prompts
Home > More > User Options > Keypad Config > Verbal Options
1.
A button toggles verbal options prompts on and off. When Verbal Chime is set to on, the WTK5504 will speak
the zone label words (e.g., 'Laundry Room Window') when the zone chimes. When Verbal Prompt is set to on,
the WTK5504 will speak system prompts (e.g., 'Quick Exit in progress').
2.
To exit press the Back or Home button.
Adjusting the Keypad Tone
Home > More > User Options > Keypad Config > Volume Setting > Tone Control
This allows you to select different tones of the keypad beeps. Use the slide bar to adjust the tone to the desired setting.
Changing the Buzzer Volume
Home > More > User Options > Keypad Config > Volume Setting > Volume
Use the slide bar to adjust buzzer volume to the desired setting.
Changing the Voice Volume
Home > More > User Options > Keypad Config > Volume Setting > Voice
Volume
When this option is selected the keypad allows you to scroll through 4 different speaker volume levels.
At each volume level, the keypad will say "test". The right side is the default setting, which is the maximum volume.
The left side is the lowest volume, but does not turn the speaker off. Use the slide bar to adjust the volume to the
desired level.
NOTE: For UL/ULC installations, the level of the buzzer shall not be changed from the default level.
Changing Language
Home > More > User Options > Keypad Config > Languages
1.
Select the desired language.
2.
To exit press the Back or Home button.
Event Buffer
Home > More > User Options > Event Buffer [Master Code]
Your panel keeps a record of events that have occurred on the system, such as when a zone is bypassed, an alarm
occurs or a zone is violated. The event buffer (log) displays the date, time and the full description of the event(s),
including zone/user label. The log is organized from the most recent event (top) to past events (down). The left arrow
scrolls forward in time. The right arrow scrolls back in time. The Back returns you to the Home screen. This screen
will time out to the Home screen after 30 seconds of inactivity.
User Functions
Home > More > User Options > User Functions [Master Code]
The user functions menu can only be accessed when the system is disarmed. Only the master code or a user code with
the supervisor attribute enabled may be used to access this mode. From this screen you can access the following
options:
• Time and Date
• System Test
• Late to Open Programming
• Late to Open - On/Off
• Auto-Arm Programming
• Auto-Arm On/Off
• Enable DLS
• User Call-Up
• User Walk Test
Time & Date Programming
Home > More > User Options > User Functions [Master Code] > Time and
Date
1.
To change the time/date press
down arrows to change time/date.
2.
To exit press the Back or Home button.
Time and Date
. Tap on the section you would like to change and use the up/
10
Publicité
Table des Matières
