2.
Install the cover to the bracket.
1). Loosen the two set screws on the bracket.
2). Fit the cover into the bracket.
3). Turn the cover to make the "FRONT" mark face the monitoring area.
4). Secure the two set screws with a hex wrench.
3.
Install the device to the bracket.
1). Hook the two ends of the safety rope to the device and the bracket respectively.
2). Route the cables through the bracket.
3). Connect the corresponding cables to the device.
Figure 2-4 Secure the Bracket
Figure 2-5 Install the Cover
Figure 2-6 Connect the Safety Rope
Figure 2-7 Connect the Cables
6