Cable Installation - Kenwood KCA-R100 Manuel D'instructions

1.5 Putting on an adhesive mount
After selecting the best installation position and angle, remove (3) Adhesive
protective film and protective lens film, stick it on the rear windshield, keep press
and add pressure for 30 seconds.
TIP
- Make sure that Cable can be connected at the installation location.
- Windshield should be thoroughly cleaned and mounting area is wiped dry and
at room temperature before applying the adhesive (Avoid under direct sunlight).
- Allow 24 hours to get the best adhesion effect.
1.6 Evaluate Cable Routing Location
Installation of the rear camera cable needs careful planning for the cable run and
the final position of the camera within the vehicle. See the device manual for
optimum front dash camera position. Study the vehicle for the most appropriate
cable run towards the front windshield.
1.7

Cable Installation

Tucking the cable into the headliner of the vehicle and hide exposed cable to pillar
trim and rubber strips, use a panel removal tool to loosen any trim and hide the
cable if necessary.
Note:
- Ensure that the routing of the cable does not affect airbags.
- Find the right place to hide excessive cable.
- Consult a professional installer or vehicle technician to start the installation
instead of doing it yourself.
07