LaserLiner SmartLine-Laser G360 Mode D'emploi page 11

The transport restraint must be released for horizontal and vertical levelling. The laser lines
!
flash and the LED lights red as soon as the device is outside the automatic levelling range
of 5°. Position the device such that it is within the levelling range. The LED switches back to
green and the laser lines stop flashing (steady light).
3
Hand receiver mode
Optional: Working with the laser receiver GRX
Use an GRX laser receiver (optional) to carry out levelling at great
distances or when the laser lines are no longer visible. To work with
a laser receiver, switch the line laser to hand-held receiver mode
by keeping button 6 (handheld receiver mode on / off) pressed.
The laser lines will now pulsate with high frequency, making the
laser lines darker. The laser receiver can detect these pulsating
laser lines.
!
Observe the laser receiver's operating instructions for line lasers.
Due to the special optics required to generate a continuous 360° laser line, the underlying
!
technology may cause differences in brightness in different areas of the line. This may lead
to different ranges in hand receiver mode.
4
Slope mode
Do not release the transport restraint, set slide switch (3) to "OFF". Select and switch on the laser
with the selection button. Sloping planes can now be measured. This mode cannot be used to
perform horizontal or vertical levelling as the laser lines are no longer aligned automatically.
The LED lights constantly red.
LASER LASER LASER LASER
SmartLine-Laser G360
LASER
3 Sek.
11
EN