Troubleshooting - Klarstein WINDWAKER ECO Manuel D'instructions

EN
114

TROUBLESHOOTING

Problem
The indoor air conditioner
cannot receive the remote
control signal or the
remote control cannot be
operated.
Possible Cause
Interference due to
electrostatic charging,
constant voltage etc.
The remote control is out of
range of the unit.
There are obstacles
between the remote
control and the air
conditioner.
The remote control is not
directed at the reception
window of the air
conditioner.
The sensitivity of the
remote control is reduced
and the screen is blurred
or does not display at all.
The remote control screen
does not display anything.
There are fluorescent
lamps in the room where
the air conditioner is
installed.
Suggested Solution
Disconnect the mains plug
from the socket. After 3
minutes, plug the mains
plug back into the socket
and switch on the device
again.
The maximum signal range
is 8 meters.
Remove the obstacles.
Hold the remote control
at the correct angle to the
receiver window of the air
conditioner.
Check the batteries. If
the batteries are empty,
replace them.
Check if the remote control
is damaged. If so, replace
them.
Place the remote control
near the air conditioner. If
it still does not work, turn
off the lights and try again.