Troubleshooting; Safety Notices; Fault Indications - Caso Germany MCDG 25 Master Mode D'emploi Original


•

•
•
•

15 Troubleshooting

This chapter provides you with important notices with regard to operating
the device. Observe the following notices to avoid dangers and damages:

15.1 Safety notices

►
►

15.2 Fault indications

In the event of a fault, an error code will appear in the display; it describes
the cause of the fault.
caso MCDG 25 Master
Exterior housing
Clean the exterior surfaces of the device with a damp cloth.
Turntable and rolling ring
The turntable must be removed and cleaned occasionally. Wash the
turntable in a warm soapy solution or in the dishwasher.
The rolling ring should be cleaned regularly to prevent excessive noise
development or rotational malfunctions.
The rolling ring can be washed in a mild soapy solution or in the
dishwasher. Please remember to put the rolling ring back again properly
after cleaning it.
Wipe the bottom of the oven with a mild cleaning agent. If the floor of
the oven is excessively dirty, you can use a mild cleaning agent.
Attention
Only qualified electricians, who have been trained by the
manufacturer, may carry out any repairs on electrical equipment.
Improperly performed repairs can cause considerable dangers for the
user and damages to the device.
Error code Description
E01 Excessive temperature within cooking chamber
The overheating cut-out terminated the current program at a
cooking chamber temperature of 250 °C.
Press the Stop button to acknowledge this fault.
The device can be re-activated after the cool down phase.
Low temperature protection
E02
When the system enters into super low temperature
protection status, the digital display shows "E02" and
continues to beep till the system comes back to normal
condition and then press "Stop".
E03 Sensor fault
71