Troubleshooting Chart - edenox DROP IN Manuel D'instructions

EN
The product is made up of metal parts and stone parts. The packaging is made of wood, plastic
and cardboard.
For any part of the appliance, please note that:
• At the end of the product's life-cycle, make sure it is not dispersed in the environment.
• Each part must be collected and disposed of separately, according to their distinctive
characteristics (e.g. metals, plastic, rubber, etc.)
• The public or private waste collection systems defined by local legislation must be
considered.
• The equipment may contain hazardous substances: the improper use or incorrect
disposal may have negative effects on human health and on the environment;
• In the event of illegal disposal of electrical and electronic waste, penalties are specified
by local waste disposal legislation.

6 TROUBLESHOOTING CHART

6.1 TROUBLESHOOTING CHART
The appliance electric motor has a electrothermal protector included that trips in the event of
overcurrent or excessive heating. When this protector trips, the appliance must be disconnected
to prevent malfunctioning.
Connect the appliance after an hour and contact your technical service in the event the problem
remains.
Some problems are due to causes that are easily resolved without having to contact the
technical service.
Please read the following table carefully:
Problem
The appliance does not work
Does not cool sufficiently
Excessive noise when operating
All the basic checks have been carried out and
the problem remains
Procedure
Check that the appliance is correctly
connected to the socket and connected to
the control panel, and that the automatic
power limiter has not tripped (still in ON
mode).
Check the regulation of the thermostat
and/or influence or direct sources of air on
the tray. Make sure that the condenser of the
cooling unit is completely clean
Make sure that the appliance is correctly
levelled.
Check the anchoring system of the appliance
elements that may have moved or become
loose.
Contact your Technical Assistance Service in
the event of fan malfunctioning.
Contact your distributor or your Technical
Assistance Service.
Instruction Manual
[18]