Maintenance; General; Cleaning - Hatco Salamander THERM-MAX TMS Serie Manuel D'utilisation Et D'entretien

MAINTENANCE

General

The THERM-MAX Salamander is designed for maximum
durability and performance with minimum maintenance.
WARNING
ELECTRIC ShOCk hAzARD:
• Turn OFF power switch, unplug power cord/turn off
power at circuit breaker, and allow unit to cool before
performing any cleaning, adjustments, or maintenance.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• Do not steam clean or use excessive water on unit.
• This unit is not "jet-proof" construction. Do not use jet-
clean spray to clean this unit.
• Do not clean unit when it is energized or hot.
• Use only Genuine hatco Replacement Parts when
service is required. Failure to use Genuine hatco
Replacement Parts will void all warranties and may
subject operators of the equipment to hazardous
electrical voltage, resulting in electrical shock or burn.
Genuine hatco Replacement Parts are specified to
operate safely in the environments in which they are
used. Some aftermarket or generic replacement parts
do not have the characteristics that will allow them to
operate safely in hatco equipment.
This unit has no "user-serviceable" parts. If service is
required on this unit, contact an Authorized hatco Service
Agent or contact the hatco Service Department at
414-671-6350; fax 414-671-3976.

Cleaning

To preserve the finish of the unit as well as maintain
performance, it is recommended that the unit be cleaned daily.
Use non-abrasive cleaners and cloths only. Abrasive
cleaners and cloths could scratch finish of unit, marring
its appearance and making it susceptible to soil
accumulation.
Clean unit daily to avoid malfunctions and maintain
sanitary operation.
1. Turn off the unit, disconnect from the power supply, and
allow the unit to cool.
2. Remove the cooking grate and drip tray, and clean
thoroughly.
3. Wipe all metal surfaces using warm water, a mild
detergent, and a non-abrasive cloth. Stubborn stains may
be removed by using stainless steel wool and rubbing in
the direction of the satin finish.
4. Rinse the unit thoroughly using a cloth dampened with
warm water only.
5. Dry the unit using a clean, dry, and non-abrasive cloth.
NOTE: If the unit is left unused for an extended period of time,
apply a thin, protective layer of Vaseline oil over all
stainless steel parts using a cloth. The area where the
unit is installed must be kept clean as well.
10
NOTICE
Form No. TMSCEM-0911