Troubleshooting:
NOTE: For any fault of the machine, please always check the charging station first, to
see if it is under proper working status(fence line is not loosen, or bite by your pets,
or cut by the blades of the machine, or your AC power shut down when the machine
is working). The lamp on the charging station will be red flashing if there's such
problem.
1. The mower does not start.
a) The mower starts in an ineffective fence line area. Check the fence line for repair.
b) Check the emergency stop switch. If the emergency stop switch is locked, press the
emergency stop switch then press red power switch.
c) If the mower has not been used for along while, the battery maybe empty. Make sure to
charge it again after charging. Even when unused, it is recommended that the battery is
charged every 3months.
2. The mower does not move forward.
a) The bumper sensor may be damaged.
b) If the grass is very long at the first time, which will shelter the sensor tube, please mow the
grass with a traditional lawn mower before using the robot mower.
3. The mower does not mow properly or at all.
a) Turn off the mower. Check if the blades are properly installed.
Replace the blades if damaged.
b)If the mower is in a slope which has an angle more than28°,the mower will automatically
stop.
c).The root part of the blade holder is stuck by objects or grass. Remove them and restart.
d) The grass is too dense to be mowed due to the automatic protection of machine.
e) the machine stopped automatically to protect the PCBs and other components when it
tested the motor temperature is too high.
4. The mower crosses the fence line and continues outside the perimeter.
a) The fence line turn angle is too steep. The inner angle must be at least 125°.
b) The fence line is too close to as lope. Adjust the fence line position to be in accordance
to the recommendations.
c) The fence line signal is weak. The fence line must not exceed 200m.
d) Check if there are any high-power appliance (such as transformer, generator, telecommu-
nications tower, ect.) nearby. Those appliances could interfere the machine signer.