Hortensus RG800 Mode D'emploi page 84

5. When you have confirmed the third starting point, the display on the screen changes
from "NEXT" to "FIN". By pressing "FIN" you are confirming the three starting points for the
individual areas. The mower stops and the following message appears on the screen:
NOTE: After you have defined the first starting point, a END button appears to the left of the
screen. If you would like to define only one starting point or only two different starting points,
you can use this to end the procedure early. Press the "END" button, thus confirming the
starting points defined. The mower stops and you can proceed as described.
6. Turn off the mower and place it clockwise in front of the charging station. Turn on the
mower again and enter the PIN code. Let the mower stand in front of the charging station
after the input and don't turn it off. It will wait there until the Start time point is reached and
then begins mowing.
Please note
a) The starting point should be selected in such a way that it is located in the center of the
sub-area to be mowed.
b) The minimum distance between two boundary wires should be more than 50 cm.
c) The sub-area function divides the mowing areas in up to three different sub-areas.
However, this does not mean that the mower mows only within the sub-area. It can also
switch to and from between the individual areas.
d) If battery is weak during the sub-area function, and the mower returns automatically to the
charging station, after completing the charging operation, it returns from there to the place
where it had stopped earlier. However, if the mower was stopped due to some other problem,
it continues its work after the charging operation but not according to the settings. It begins
again with the next day specified from the first starting point to the third starting point.