Amibot Swift CONNECT Manuel D'utilisation page 16

EN
Troubleshooting
The robot does
04 not move cor-
rectly.
The LED light
flashes blue
05 even after
charging for 4
hours.
The robot does
06
not start.
If none of the above-mentioned steps provide a solution for your
problem, please contact the AMIBOT after-sales department.
1. The floor is wet.
2. The dustbin is not
attached correctly.
3. The gap sensors
are dirty.
4. The robot is used
on dark-coloured
floors.
1. Charging was
interrupted.
1. The battery is not
inserted correctly.
2. The battery is too
weak.
3. The robot is
switched off.
14
1. Dry the floor.
2. Remove and reinsert the
dustbin.
3. Clean the gap sensors
with a soft cloth.
4. Place the robot on a light-
coloured floor.
1. Check that the robot is
plugged into the adapter
and mains supply.
1. Check that the battery is
inserted correctly.
2. Charge the robot until the
LED light is steady blue.
3. Switch the robot on by
pressing the power button
for 3 seconds.