DAITEM DP8000 Mode D'emploi page 21

DP8406/DP8407/DP8408
G Put the central unit in test mode
G Connect the 7,2 V lithium battery
NB: when you connect the battery, the siren emits a 3 sec confirmation tone and automati-
cally goes into test mode.
If you have already learning the personal radio with the remote control, it isn''t necessary to
restart the learning with the keypad
During test mode, the tamper function of the siren is disabled to avoid any unexpected
operation of the siren during its installation.
G Take one of the systems remote controls or gain access to the systems keypad.
G Briefly press (less than 2 sec) the sirens learning button. The siren confirms by emitting a
short sound and goes into "learning" mode for 10 sec.
G Hold the "Off" button of the remote control or send 2 consecutive "Off" commands from
the keypad. The siren confirms successful learning by emitting a long tone.
"bip"
or
2
1) Briefly press
(less than 2 sec)
the sirens learning
button.
L e a r n i n g t h e p e r s o n a l r a d i o c o d e
Arrêt
Partielle
Totale
Appel
Wait for 2
seconds
before holding
1
the button
1 1
!
master code
10 sec max.
2) Hold the "Off" button of the remote
control or send 2 consecutive "Off"
commands from the keypad*.
"biiiiip"
)
)
)
)
)
NB: if any "Off" command is sent or if
the learning is not correct, the siren
indicates the error by 3 short beeps. In
3) The siren confirms
successful learning this case it is necessary to restart the
by emitting a long tone.
process from the beginning.
GB
21