I n s t a l l a t i o n
You now need to proceed to the installa-
tion of the siren. We advise you to follow
the stages described in this chapter. If the
siren does not perform as expected please
re-start the installation procedure as nec-
essary.
GB
20
Necessary materials
G 1 crosshead and a flat screwdriver.
G 1 drill with 6 mm Ø masonry bit.
G The fixing accessories supplied.
Opening
G Remove the securing screw from the
base (see view of the bottom of the siren).
G Unlock the battery cover in the base of
the siren.
G Open the battery cover.
Rear view of the siren
Battery
cover
locking
screw
Guarantee label
G Remove the detachable half of the guar-
antee label and affix it to the guarantee
extension request form supplied with the
control panel's documentation.
G In the event of this being an addition to
a system: Affix the Label to the guarantee
extension request supplied with the prod-
uct and send it to the address indicated on
documents supplied.
Siren's bottom view
Strobe
Base
Auto protection tab
Battery
cover
Speaker
Housing set screw
Guarantee
label
Daitem