Cleaning; Restoring The Factory Settings - Alpha IP RTA 61001 Serie Mode D'emploi

5. Position the room control unit Analog onto the installation bottom and latch it in.
9 The room control unit performs a self-test for the duration of approximately 2
seconds.
9 This is followed by the initialisation.
9 After that, the test indication flashes (in orange and green).

9 Cleaning

Clean the device with a soft, clean, dry, and lint-free cloth. In order to remove heavy
contamination, moisten the cloth slightly with lukewarm water. Use a solvent-free
detergent for cleaning.

10 Restoring the factory settings

The reset to factory setting will delete all settings made by the user.
Alpha IP Access Point (app)
1. Delete the device from the Alpha IP.
Stand-alone operation
1. Take off the device from the installation bottom (see fig. 5 page 5).
2. Remove the batteries.
3. Re-insert the batteries according to the marking in the battery compartments.
At the same time press the system key (C) for 4 seconds until the LED flashes
rapidly in orange.
4. Release the system key (C).
Restoring the factory settings
41