Prior To Use; Inserting The Batteries - SilverCrest SFS 18 A1 Manuel D'utilisation Et Informations Sur Les Services

Prior to use

The remote control is powered by 2 batteries of type AAA,
LR03, 1.5V. These are supplied.
In its original
batteries are already inserted
in the battery compartment. To
use the device for the first time,
you only have to remove the
plastic strip which is inserted
between the battery and the
battery contacts. Proceed as
follows:
1. Open
compartment
2. Remove the plastic strip

Inserting the batteries

Open the battery compartment
on the rear of the remote
control by removing its cover in
the direction of the arrow.
Insert the batteries with the
correct polarity as shown in the
adjoining
correct polarity is illustrated in
the battery compartment and
on the batteries. Close the
battery
When the performance of the
remote control
replace the batteries with new
batteries of the same type. The
device does not indicate when
the battery
exhausted.
state,
the battery
illustration.
compartment.
decreases,
capacity
Programmed codes are stored permanently
and are not lost when the batteries are
changed.
SilverCrest SFS 18 A1
the
The
is
English - 69