Kohler MasterShower K-75 Instructions D'installation page 4

2. INSTALLATION
Familiarize yourself with the MasterShower tower
assemblies before proceeding. See Fig. #5 .
Sheetflow
Assembly
Tower
Assembly
Manifold
Assembly
Circuit Board
Key Pad
TB1 Plug
Rite-Temp
Handle
Body
Spray
End Cap
Assembly
A. TRANSFORMER KIT:
1.
See Fig. #6 . Mount transformer kit at roughed-in location.
Allow clearance for knockout for electrical service. Remove
cover plate. Secure with wood screws through two mounting
holes. Route SJO cord between transformer enclosure and
mounting box rough opening. Re-install cover plate.
Do not make electrical connection to transformer yet,
unless power to transformer can be left off until after
MasterShower tower and Hand Shower installation is
complete.
Enclosure
Screw
Cover
A
1017708-2-
Hand Shower Outlet
Transformer
Fig. #6
Strain Relief
Hose From Manifold
Strainer
Screw
Screw
Cover
Fig. #5
B. MOUNTING BOX AND VALVE ASSEMBLY:
1.
Install finish wall before proceeding with MasterShower tower
installation.
2.
Turn off water to supply risers. Uncap risers, if applicable.
Confirm proper riser height.
3.
See Fig. #7 . Slide one male threaded adapter (not supplied)
over each riser. Solder male threaded adapters to risers. Top
of adapter should be 39-1/8" (99.4cm) above floor after
soldering.
4
Enclosure
Transformer
Male Threaded
Adapter
Pipes
2x4's
Fig. #7
Kohler Co.