Battery Installation - HoMedics JUMBO DISPLAY Manuel

BATTERY INSTALLATION

Low battery warning
When the batteries get weak, the battery warning symbol
appears . It is still possible to measure temperature.
The batteries must be replaced. When the battery symbol
flashes and Lo appears in the display, the batteries must be replaced. If the
batteries are too flat, then the thermometer will switch off automatically.
NOTE:
• It is recommended to remove the batteries if the unit will not be used for an extended
period of time.
• Please store batteries away from small children and heat.
• Do not use rechargeable batteries.
• Dispose of used batteries in accordance with the applicable legal regulations.
Never dispose of batteries in the normal household waste.
Replacing the Battery
1. Use a Phillips head screwdriver to loosen battery cover screw. Remove the battery
cover.
2. Remove used battery.
3. Replace with a lithium 3V CR2032 battery in designated area. The + sign on the
battery should be facing upwards.
4. Place the battery cover on the thermometer and tighten the screw to secure it
in place.
8 | GB