Battery Installation - HoMedics HTD8816C TE-350-EU Mode D'emploi

OPERATION

Battery installation

Caution: The Non-Contact Infrared Body Thermometer does not operate with dead
batteries or external power sources. Install new batteries.
1. Slide the battery door downward, toward the bottom of the Non-Contact Infrared
Body Thermometer, and remove the battery access door;
2. Insert two pieces AAA size batteries according to the "+" and "-";
3. Close the battery cover.
How to operate
Before applying the Thermometer, be sure to read and understand all warnings listed of
the instructions before use.
• The thermometer is aligned with the middle of the forehead to measure body
temperature between the eyebrows above and keep the vertical distance, press the
On/scan button, temperature will display immediately, see figure 2.
• When the ambient temperature of the thermometer changes too much, such as
moving the Thermometer from one place of lower temperature to another place of
higher temperature, allow the thermometer to remain in a room for 30 minutes where
the temperature is between 15°C to 40°C.
• The ambient temperature around the test person should be stable, should keep away
from the larger flow fan, air-conditioning vents and so on.
• When people moving from one place of lower temperature to another place of higher
temperature, should at least remain in the test environment more than 5 minutes, to
be consistent with the ambient temperature after the re-measurement.
1cm-5cm
Figure 2: Measuring position and distance
GB | 10