FCC Caution: To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compli-
ance could void the user's authority to operate this equipment. (Example - use only shielded interface cables when connecting to computer
or peripheral device. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions. (1) This device
may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause
undesired operation.
REMOTE PAIRING:
RF REMOTE FUNCTIONS:
Blower On/
Blower On/
1
2
Speed Selection
Power Off
3
4
Lights On/Dim/Off
10 Min Delay Off
RF REMOTE FEATURES:
storage. The remote may be placed on any magnetic surface such as a
refrigerator or the Zephyr remote holder, FIG. 1. The remote holder can
be inserted into a standard electrical outlet for easy storage. Note: The
remote holder does not charge the RF remote.
Maximum remote control communication distance is 15 feet from the hood.
RF REMOTE MAINTENANCE:
Clean the remote control using non abrasive detergents
Follow instructions below for replacing battery.
A
Remove the battery and replace with battery type A23 12V.
Negative end of battery should face the spring inside the remote.
Re-install battery door and recycle old battery.
THE RF REMOVE CONTROL IS AN OPTIONAL
ACCESSORY NOT INCLUDED WITH THE HOOD AND
MUST BE PURCHASED SEPARATELY
Blower On / Speed Selection
1
Press
to power on blower and cycle through all six blower speeds.
Blower On / Power Off
2
By pressing
, the blowers will power on at the last speed setting. Press
again and the entire hood will power off, including lights.
Delay Off
3
By pressing
, the blower and lights will enter Delay Off mode. The blower wil
change to speed 1 and shut down after 10 minutes.
Lights On / Dim / Off
4
Switch lights On by pressing
15
once, again to dim and again to switch Off.
FIG. 1
+
A
FIG. 2
-