Vollrath 59502 Manuel De L'opérateur page 7

TROUBLESHOOTING
Problem
The equipment turned off after 10
minutes.
The equipment is on, but not
heating.
The Power Level LEDs are flashing. The overheat-protection feature may
The equipment suddenly stopped
working.
®
Mirage Induction Buffet Warmers Operator's Manual
Might be Caused By
There is not a serving vessel on the
induction warmer or the vessel is not
induction ready. The induction warmer
turned off. This is normal.
The serving vessel may be too small or
may not be induction ready.
have activated.
The equipment may be too close to an
external heat source or the air intake
may be restricted.
Course of Action
Make sure the serving vessel is induction ready. See the Function
and Purpose section of this manual.
Make sure the serving vessel is induction ready. See the Function
and Purpose section of this manual.
Remove the serving vessel. Let the equipment cool for
approximately 15 minutes. When the overheat condition has
cleared, the equipment will return to normal function.
Relocate the equipment away from any external heat source. Clear
any obstructions to the air intake.
7