Pentatech DF300 Set Mode D'emploi page 34

34 - GB
[58] Network Setup
• Internet Setup - do not change the DHCP setting (this makes the automatic connection with your home
network possible)
• Security code - the code can be changed from the default 123456
• Network Information
up the internet function
[53] Alarm Setup (Melody setting for Alarm clock and Timer)
• Period - Select the duration of the melody
• Melody - Select the desired melody
(The times should be set in the submenu/Time/Clock Alarm)
[55] System Setup
[60] Power Saving
Power Saving On (Enable) or Off (Disable)
When power saving is enabled, the screen will switch to black after 2 minutes after the last use. To
show the screen again tap the On/Off button [8]. During Motion detection or Scheduled Recording
the screen will automatically switch on.
Default: disabled
[62] Screen Auto-lock
Auto-lock enabled/disabled
30 seconds after the last use all the touch screen tabs will be removed from the screen, the camera
image remains. To reenable the touch screen,tap the On/off button [8]
Default: disabled
[64] Time Menu
• Clock Alarm
Default: no times set
• Time Setting
• Timer
(AM: 0.00-12.00 / PM: 12.00-24.00)
[59] Format Storage
The SD card can be manually formatted in which case all recorded date will be deleted, or the
Overwrite function can be selected. This activates a ring memory, so that when the SD card is full
the oldest data will be automatically overwritten.
[61] System Upgrade
In case of any new firmware, this will be found in "www.indexa.de" in Download section
• Remove the SD card from the monitor.
• Load the new firmware-software from your PC to the SD card.
• Insert the SD card into the monitor.
• Start the "System-Upgrade"
The version number of the firmware in the monitor can be found in Network settings [58] / Network
Information.
[63] Default
After selecting the language the monitor will switch off automatically. Switch on the monitor
(button x) and follow the instructions on the screen. The default settings are reactivated.
[57] Quick Tips for following subjects:
Installation and service range / How to set up motion detection / Instant Record / View recorded video / Storage and
delete / Connect to internet / Remote viewing access / PTZ operation / How to pair a new camera / Power Save mode
- the DID (Device Identification Number) is listed here, this is required for setting
- 5 Wake-up times can be set and activted (tick) or deactivated (X)
- Set the real time and date
- After the set duration (maximum 59 minutes and 59 seconds) the melody will sound
/ Select Overwrite function
- Reset and menu language selection