Proper Use; Features And Equipment - Pentatech DF300 Set Mode D'emploi

GB Operating instructions
1. Introduction
Read through these operating instructions fully and carefully and while doing so
fold out page 3 with the illustrations. The operating instructions belong to this
product and contain important points concerning bringing the appliance into
service and its operation. Always pay attention to all safety instructions. Should
you have any questions or be unsure about operating the appliance ask a
specialist. Keep these instructions in a safe place and should the need arise pass
them on to a third party.

2. Proper use

The wireless camera set consists of the camera DF300K and monitor
(v2)
with two mains adaptors and docking station.
It is to be used for the surveillance of rooms, entrance hallways, driveways etc.
through video pictures and sound. The video and audio transmission is wireless
using a frequency of 2.4GHz.
The power is supplied through the supplied mains adapters connected to a
230VAC, 50Hz mains supply. The monitor contains a rechargable lithium battery
which is automatically recharged whenever the monitor is placed into the docking
station. The battery can power the monitor for up to two hours portable operation.
If there is sufficient light a colour picture will be transmitted. At low ambient light
levels the integrated Infrared LEDs are automatically switched on. In this case the
immediate area (max. 20 m) will be illuminated and the video picture switches to
black and white mode for improved light sensitivity. The picture quality is
optimised for day and night opereation by an internal mechanical filter change. If
the surveillance is specifically required in a dark environment, then additional
lighting should be installed.
Up to four wireless cameras DF300K can be used with one monitor. The camera
channels can be manually selected or automatically displayed in sequence if the
scan mode is selected. The camera pictures can also be observed simultaneously in
quad-split screen mode. The wireless transmission is digital and on constantly
changing frequencies (frequency hopping) which are synchronised between the
camera and the monitor. Only the receiver which has been "paired" with the
camera can receive the synchronised signals. This security feature prevents access
of the camera signal by third parties.
The camera is weatherproof (Protection class IP66) and can be used not only
indoors but also for mounting outside. Wherever possible it should be protected
from direct rainfall. The monitor and both mains adapters are for indoor use only
and must be protected from moisture.
The monitor with inbuilt wireless receiver can be controlled using the touchscreen
display.
Video and audio can be recorded onto an SDHC card (max. 32 GB, not included)
through the monitor. The recording can be started manually, using a schedule, or
automatically through a motion detection software.
recordings in a ring format so that the oldest recordings will be automatically
overwritten when the card is full.
for the event log and for scheduled recordings. This can also be used as an
alarmclock and countdown timer.
monitor, using a PC or through an App on a smartphone or tablet.
When the monitor is placed in the docking station and the docking station is
connected with the local network with the network cable, then the system can
be operated from a smartphone or tablet which is connected with that network.
30 - GB
It is possible to store the
The built-in real time clock and calender is used
The recordings can be viewed directly on the
Apps are available for iPhone and Anroid, the system is not compatible with
Windows and Blackberry smartphones.
If the local network is connected to the internet then the viewing through the App is
possible via internet (a minimum upload speed or badwidth of 512Kbps is
required). The system is able to send an Email message to report motion
detection.
The set is for use in private households. A video surveillance system does not
replace your duty of care or supervision. Observe the regulations concerning video
surveillance in commercial and public areas.
Any other use or modification of the device is not authorised. No liability will be
accepted for consequential damages or for damages caused by improper use or
incorrect operation. No liability will be accepted for consequential damages
caused by any function or by malfunction. Unless any liability is specifically
DF300M
required by law, claims for damages, in particular those for personal injury or
property damage caused by non-functioning or malfunctioning of the machine,
are excluded.
This appliance is not intended to be used by people (including children) with
restricted physical, sensory or mental capacities, or a lack of experience and/or
knowledge, unless they are supervised by, or receive instructions how to use the
appliance from a person responsible for their safety.
3. Package conten
! DF300K camera with connection
cable to mains adapter
!
Antenna
!
DF300M (v2)
Monitor
!
Docking station DF300D

4. Features and Equipment

Monitor DF300M (s. fig. A)
1 Antenna
2 Connection for docking station
3 Screen
4 Mains adapter connection
5 Reset button
Docking station DF300D (s. fig. A)
10 Connection for monitor
11 Mains adapter
12 Mains adapter connection
Camera DF300K (s. fig. B)
15 Daylightsensor
16 Power LED
17 Lens
18 Infrared LEDs
19 Connection-LED
20 Antenna connection
21 Fixing hole for bracket
22 Microphone
23 Pairing button
24 Mains adapter connection
25 Triangular nut
26 Wing screw
ts (s. fig. A + B)
!
2x mains adapter 5VDC
!
Network cable 2 m
!
Camera bracket with screws and
plugs
!
User manual
6 Slot for SD-card
7 Stand
8 On/off button
9 Loudspeaker
13 Network connection
14 Network cable
27 Bracket
28 Antenna
29 Plugs
30 Mains adapter
31 Screws
Screen displays
Screen A
32 Open menu
33 SD card status (red when card
not inserted or damaged)
(see Fig. C)