TechniSat DIGITRADIO 210 Mode D'emploi page 51

>Push Tune up/down (6) for choosing whether the automatic channel scan should
stop for each channel ( all channels) or only for stations with strong signal level (Only
strong stations).
Note, very poorly reproduced that occur depending on the setting, either transmitter
or skipped that.
Audio Setup
>Open the menu by pressing the Menu (8).
>Push Tune up/down (6) until you have reached the point audio setting.
>Now press Select (7).
>Push Tune up/down (6) to choose whether the sound should be played exclusively in
mono (mono only) or, if available, also in stereo (Stereo Audio).
If the sound is reproduced noisy, so the selection of mono only lead to a reduction of
the noise.
Language
>Open the menu by pressing the Menu (8).
>Push Tune up/down (6) until you have reached the point Language / Select (4).
>Now press Select (7).
15