Worx WG153 Mode D'emploi page 13

TROuBLESHOOTING
The following table gives checks and actions that you can perform if your machine does not
operate correctly. If these do not identify and correct the problem, contact your service agent.
wARNiNG: Switch the machine off and remove the battery prior to any
troubleshooting.
Problems
Trimmer fails to
operate.
Trimmer runs
intermittently.
Excessive
vibrations/noise.
Cutting time per
battery charge
too low.
Machine does not
cut.
Auto feed does
not work
10 Grass Trimmer/Edger
"
Possible Causes
Battery discharged.
Battery too hot/cold.
Motor is broken.
Internal wiring of machine
damaged.
Motor is broken.
Battery not fully charged.
On/Off switch defective.
Machine defective.
Line spool is not wound well.
Battery has not been used for long
period or only charged for short
term.
Grass too high.
Battery defective.
Line broken.
Battery not fully charged.
Motor is broken (speed is too low).
Grass entangled around cutting
head.
Cutting line is not wound well.
The line is tangled.
Line is used up.
Corrective Action
Recharge battery; also see the
content in charger manual
Allow to cool/warm.
Contact Service Agent.
Contact Service Agent.
Contact Service Agent.
Recharge battery.
Contact Service Agent.
Contact Service Agent.
Rewind the line. See '' To fit spool
and line assembly.''
Fully charge battery; also see
the content in charger manual
Cut in stages.
Replace the battery.
Replace the line.
Recharge battery; also see the
content in charger manual
Contact Service Agent.
Remove grass.
Manually feed the line, if still can
not feed out, remove the spool out
and rewind the line.
Replace with a new line spool.
13
EN