Hach ORBISPHERE 410 Manuel D'utilisation Simplifié page 3

Table of Contents
1 Specifications on page 3
2 Online user manual
3 General information
4 Installation on page 6
Section 1 Specifications
Specifications are subject to change without notice.
Specification
Ambient
temperature
Storage
temperature
Operating humidity
Operating altitude
EMC requirements
Korean registration
Compliance
Pollution degree
Enclosure ratings
Power supply
Analog current
output version on
the measurement
board
on page 4
on page 4
Details
–5 to 50°C (23 to 122°F)
–20 to 70°C (–4 to 158°F)
0 to 95% non-condensing relative humidity
From 0 to 2,000 m. (6,550 ft.) above sea level
EN61326-1: EMC Directive
Note: The wall mount instrument is a Class A product. In a domestic environment this product may
cause radio interference in which case the user may be required to take adequate measures.
User Guidance for EMC Class A Equipment
업무용을 위한 EMC 등급 A 장치에 대한
사용자 지침
사용자안내문
A 급 기기 ( 업무용 방송통신기자재 )
이 기기는 업무용 (A 급 ) 전자파적합기기로서 판매자 또는 사용자는 이 점을
주의하시기 바라며 , 가정외의 지역에서 사용하는 것을 목적으로 합니다.
CE, ETL certified to UL and CSA safety standards (with all sensor types),
FCC, KC, RCM, EAC, UKCA, SABS
2
IP 65; Totally protected against dust; Protected against low pressure jets of
water from all directions.
NEMA 4X (wall mount only); Totally protected against dust; Protected
against pressure jets of water from all directions.
Enclosure rating does not apply to external power supply for benchtop
instruments.
Universal 100 VAC to 240 VAC ±10% @ 50/60Hz - 40VA; 10 to 30 VDC -
30W
4-20 mA (default) or 0-20 mA (configuration with software);
3 configurable outputs; Maximum load: 500 ohm; Sensitivity: 20μA;
Accuracy: ± 0.5% (between operating temperature limits)
5 User interface on page 14
6 Start up on page 15
7 Operation on page 15
8 Maintenance on page 24
W A R N I N G
English 3