Table des Matières
Publicité
GB
1. CONTROLS
Button - ON/OFF
Button - LIGHT
Button - MODE
Button - PLUS, MINUS
Radio remote control for the radiators under the bench
Button - PLUS
Button - MINUS
Button - ON/OFF
2. CHANGING THE LANGUAGE
MODE
Hold the
-button in the standby mode (dark display) for
5 seconds.
Change the language by pressing the
(German -> English -> French -> Italian -> Dutch).
MODE
Confirm by pressing the
3. LIGHT
Switch the light ON/OFF by using the
cabin is equipped with an LED spot, you have to switch it on
by using the remote control.
4. SWITCHING ON THE INFRARED CABIN
ON/OFF
By pressing the
-button the cabin is switched ON/
OFF. Start by pressing the
MINUS
-button without steamer.
The infrared cabin starts with the last setting values (the values
remain stored even after a power failure). The evaporator al-
ways starts with 100%.
The radiators under the bench also start with the last setting
values. You can switch the radiators ON/OFF by using the radio
remote control. Adjust the power between 40% and 100% with
PLUS
MINUS
the buttons
and
Operating instruction control unit
PLUS
-button.
-button.
LIGHT
-button. If your
PLUS
-button with steamer and the
.
5. SETTINGS
1 x Mode - Infrared A-radiator1
MODE
By pressing the
-button (1x) the intensity of „radiator
PLUS
1" is adjustable. With
intensity can be adjusted from 40 to 100 % in steps of 5 %
2 x Mode - Infrared A-radiator 2
MODE
By pressing the
-button (2x) the intensity of „radiator
PLUS
2" is adjustable. With
intensity can be adjusted from 40 to 100 % in steps of 5 %
3 x Mode - Salt evaporator
MODE
By pressing the
-button (3x) the intensity of the salt
evaporator is adjustable. With
evaporator intensity can be adjusted from 0, 40 to 100 %
in steps of 10 %
4 x Mode - Cabin temperature
Adjustment of the desired cabin temperature from 30 to
60 °C. At a cabin temperature of 60 °C all radiators are
automatically switched off for safety reasons (at a cabin
temperature of 59 °C they are activated again).
5 x Mode - Surface heating
Adjustment of the desired surface temperature of the
surface heating elements from 30 to 80°C.
6 x Mode - Running time
PLUS
Setting of the time with
2 h (in steps of 10 min.)
Important: The display returns to normal operation after 5
sec. without pressing a button (on the top right
side of the display the 5 sec. are counted down).
6. SWITCHING OFF
Switching off by briefly pressing the
7. RESET TO MANUFACTORY SETTING
If you want to reset to the manufactory settings
(operating time: 60 min, cabin temp.: 60 °C,
surface heating: 80 °C, infrared A radiator intensity: 100 %),
MINUS
PLUS
keep the
+
+
same time. The display will show:
ATTENTION !
reset to
manufactory
setting !
MINUS
and
the radiation
MINUS
and
the radiation
PLUS
MINUS
and
the
MINUS
and
from 10 min to
ON/OFF
-button.
MODE
-button pressed at the
18
Publicité
Table des Matières
