GoodHome Duala Manuel D'utilisation page 13

. .
. .
Use
. .
. .
. .
.
Setting the ECO mode temperature
The Comfort and ECO setpoint temperatures are
set separately.
The ECO mode temperature range is between 13 °C
and 29.5 °C and can be adjusted in increments of
0.5 °C. If limited, increase the Comfort temperature,
as the ECO temperature is always lower than the
Comfort temperature.
• When ECO mode (Eco) is in operation, press the
+ or - button to increase or reduce the setpoint
temperature. The temperature flashes.
• Press the button to cancel the setting,
or the OK-boost button to validate the ECO
temperature selected.
Setting the Boost
The temperature setting is automatically forced
to 30 °C during boost. When Boost finishes, the
thermostat returns to the mode and temperature
that was previously set.
• Press and hold for 3 seconds on the OK-boost
button to switch Boost on or off.
• Press the + or - button to select the Boost time:
5, 10, 15, 20, 30, 45, 60, 90 or 120 minutes (the
default selection is 60 minutes). Then press the
OK-boost button to validate the selection; the
remaining time in Boost is displayed.
• Press the MENU button to stop the Boost.
In Programme mode, Boost can be stopped at any
time by pressing and holding for 3 seconds on the
OK-boost. Following a manual stop in
Programme mode, Boost can only be reactivated by
a programme after a period of 2 hours.
Precautions for use
Setting the temperature
• The heating power is maximal as long as the
setpoint temperature has not been reached.
Programming the setpoint temperature to the
maximum temperature possible, will not heat the
room quicker.
• Wait several hours for the room temperature
to stabilise before adjusting the temperature
setting.
• Shut down the appliance when ventilating the
room.
Power cuts
• Following a power cut and resume, the
appliance will automatically restart with all of the
settings and programs used before the cut (if
it was in operation before the cut, it will stay on
after the power resume).
• The programmer clock starts from the time the
cut began. This means that the time and day
could be misaligned.
• Following a power resume, the reference, then
the total time the appliance is turned on is
displayed for 30 seconds on power resume.
13