Configuring The Battery Charger; Configuration Map; Configuration Mode; Onboard Display And Control Panel - Kussmaul Electronics Kussmaul Chief Auto Charge Guide D'utilisation

Configuring the Battery Charger

Configuring the Battery Charger

Once the charger is connected to AC, it is live and it may be
configured. The indicator LEDs on the onboard display will
illuminate for a second (power on test) before reporting charging
and battery status information.

Configuration Map

NOTE: There are four levels of configuration with the Auto Charge. Each setting
in different levels is accessible via the touchscreen interface provided on the unit.
Basic Settings
Advanced Settings
Home screen Menu
Notifications
Info
40
Battery Type
BAT3
Charge Mode
BAT2
Max Charge Current
BAT1
Charge Time
Copy From USB
Enable Equalize
Copy To USB
Copy from Battery
High Temp
Alarm
High AC
Display
High DC
Battery Temp
Low Temp
CEC Mode
Low AC
Reset to Default
Low DC
Event List
Firmware Update Available
Event Logs Available
Charger
USB
Run Time
Event Logs

Configuration Mode

1. From any screen, press
2. From the Home screen, press
3. Press either Basic Settings or Advanced Settings to
enter into Configuration Mode.

Onboard Display and Control Panel

When the charger is connected to at least one battery bank and to
AC , the onboard display will turn on and start reporting charging
and battery status information. Figure 15 shows the Home screen.
The onboard display is equipped with a touch screen interface.
Figure 15 Onboard Display and Control
A
A LED indicators
B C D E F G
F
B Main Menu
BAT1 (LFP) BAT2 (Flooded) BAT3 (Flooded)
H
C Shows up when
13.4 V 13.5 V 13.2 V
20.7 A 20.9 A 20.5 A
D Home screen
I Float Float Bulk
E Shows up when USB
J
Kussmaul Chief Auto Charge Battery Charger Owner's Guide
to go to the Home screen.
to go to the Menu screen.
F Shows up when the unit fan is
activated
G Battery Temperature Sensor (BTS)
reading (requires optional BTS)
H Battery level shows up when a battery
Notifications are is connected and detected by the
present charger.
I Charging state
J Control buttons
device is connected Home|Menu|Basic Set.|Advanced Set.