Kussmaul Electronics Kussmaul Chief Auto Charge Guide D'utilisation page 38

5. Temporarily remove the wiring strain relief bar by removing
the screws and detaching the bar.
Figure 8 Removing the strain relief bar
NOTE: Use a Philips #2 screwdriver to loosen the wiring strain relief
bar screw(s).
NOTICE
REVERSE POLARITY DAMAGE
Before proceeding to the next step, carefully check the wiring
polarity. Do not reverse the connections. See note below.
Failure to follow these instructions can result in equipment
damage.
975-1023-01-01
NOTE: Make sure the positive terminals of the Auto Charge will be
connected to the correct terminal of the 80A DC Circuit Breaker (PN:
090-0080-0) or a DC fused disconnect and from there to the
positive terminal of the battery. Make sure the negative terminal of
the Auto Charge will be connected to the battery negative terminal
(or DC negative bus). Connect the negative cable to the negative
DC terminal on the charger.
25