Coleman Piscines Power Steel 13784 Notice D'utilisation page 5

4
5
Connection Valve Assembly
For pool with connection valve.
A
Filling Pool with Water
ATTENTION:
Do not leave pool unattended while filling with water.
1. Fill pool until water capacity is 90%, DO NOT OVERFILL as this could cause the
pool to collapse. In times of heavy rainfall you may need to empty some of the
water to ensure the level is correct.
2. When filling the pool is completed, check that the water is not collecting on any
side to ensure the pool is level.
IMPORTANT:
If pool is not level, drain water and re-level ground by
digging out. Never attempt to move the pool with water in it, serious personal injury
or damage to the pool may result.
WARNING:
Your pool may
contain a great deal of pressure. If your
pool has any bulge or uneven side then
the pool is not level, the sides may burst
and the water may discharge suddenly
causing serious personal injury and/or
damage to property.
3. Check pool for any leaks at valves or
seams, check ground cloth for any
evident water loss. Do not add chemicals
B
E
1in. - 2in.
2-5 cm
B
until this has been done.
NOTE:
In the event of a leak, patch your pool using the underwater
adhesive repair patch provided. Refer to the FAQ's for further information.
Proper Water Level
NOTE:
Drawings for illustration purpose only. May not reflect actual product.
Not to scale.
Pool Maintenance
If you do not adhere to the maintenance guidelines below, your health might be at
risk, especially that of your children.
IMPORTANT:
If you don't respect the ideal values of the water
chemicals the PVC can be damaged and become discolor.
The following table lists the sequence of the tests that should be carried out for the
ideal values and possible actions. Regularly check the pH value and chlorine
concentration weekly and adjust to the ideal values.
TEST
pH value
Cyanuric acid
Free chlorine
Chlorine compound
Algae
Calcium hardness
To keep your pool clean:
1. Contact your local pool supply shop for advice and purchase of chemicals and pH
kits. One of the most important factors to increase the life of the liner is to keep
continuously clean and healthy water. Please strictly follow the instructions from
professional technicians for the water treatment through the use of chemicals.
2. Locate a bucket of water next to pool to clean users' feet before entering pool.
3. Cover the pool when not in use.
4. Skim pool regularly to avoid settled dirt.
5. Check and wash the filter cartridge regularly.
6. Gently clean any scum from below the top ring with a clean cloth.
7. Please be careful in case of rain water, kindly check that the water level is not
higher than the expected. If so, YOU HAVE TO DISCHARGE THE EXCESS
WATER.
Proper maintenance can maximize the life of your pool.
During the season of use of the swimming pool, the filtration system must be
necessarily put into service every day, enough time to assure at least a complete
renewal of the volume of water.
ATTENTION:
Do not use pump when pool is in use.
During the season of use of the swimming pool, the filtration system must be
necessarily put into service every day, enough for a long time to assure at least a
complete renewal of the volume of water.
Repair
Check pool for any leaks from valves or seams, check the ground cloth for any
evident water loss. Do not add chemicals until this has been done.
NOTE:
In the event of a leak, patch your pool using the underwater adhesive
repair patch provided. Refer to the FAQs for further information.
Dismantling
1. Unscrew the drain valve cap on the outside of the pool counter clockwise and
remove.
2. Connect the adaptor to the hose and put the other end of the hose in the area
where you are going to drain your pool. (Check local regulations for drainage
by-laws).
3. Screw control ring of the hose adaptor clockwise onto the drain valve. The drain
valve will be open and water will start to drain automatically.
ATTENTION:
Water flow can be controlled with the control ring.
4. When draining is finished, unscrew the control ring to close the valve.
5. Disconnect the hose.
6. Screw the cap back onto the drain valve.
7. Air dry pool.
ATTENTION:
Do not leave the drained pool outside.
5
0°
IDEAL VALUES
7.4– 7.6
30 – 50 ppm
2 – 4 ppm
0
None visible
200 – 400 ppm
P-S-004794