For Your Safety - Flex ALC 514 Notice D'emploi

Contents

For your safety . . . . . . . . . . . . . . . . 12

Overview . . . . . . . . . . . . . . . . . . . . 14
Technical specifications . . . . . . . . . 15
Operating instructions . . . . . . . . . . 15
Maintenance and care . . . . . . . . . . 19
Disposal information . . . . . . . . . . . . 19
CE Declaration of Conformity . . . . . 19
Guarantee . . . . . . . . . . . . . . . . . . . 20
Symbols used in this manual
Caution!
Denotes a possibly dangerous situation. Non-
observance of this warning may result in slight
injury or damage to property.
Note
Denotes application tips and important
information.
Symbols on the power tool
Before switching on the power
tool, read the operating manual!
Wear goggles!
Disposal information for the old
machine!
(See page 19)
For your safety
Before using the power tool, read and follow:
- these operating instructions,
- the currently valid site rules and the
regulations for the prevention of accidents.
This power tool is state of the art and has
been constructed in accordance with the
acknowledged safety regulations.
12
The power tool may be operated only if it is
- used as intended,
- in perfect working order.
Faults which impair safety must be repaired
immediately.
Laser classification
The power tool conforms to a class 2M laser
based on the standard IEC 825-1/EN 60825.
Eyes must be protected with the eyelid close
reflex in case you accidentally glance into
the laser beam. However, this eyelid
protective reflex may be impaired by
medication, alcohol or drugs. These
machines may be used without taking any
further precautionary measures provided
that there are no optical instruments which
can reduce the cross-section of the beam.
Do not aim the laser beam at people.
Identification on the power tool
Laser radiation! Do not look into the beam or
observe directly with optical instruments.
Laser class 2M in accordance with DIN
EN60825-1:2001-11
λ = 635-670 nm; H ≤ 25 W/m²
Electromagnetic compatibility
Although the power tool satisfies the strict
requirements specified in the relevant
directives, it cannot be excluded that the
power tool
- will affect other power tools (e.g.
navigation equipment on aircraft) or
- itself will be affected by high radiation,
resulting in a malfunction.
In these or other uncertain cases, check
measurements should be taken.
Line laser