Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Use caution when descaling your espresso
•
machine as the acid substance within the
descaling powder may damage countertops
or any other surface it comes in contact
with.
• The warranty of this machine does not
include espresso machines that do not
function, or do not function properly,
because descaling has not been carried
out.
We would advise you to use the Krups
descaling solution that is available from Krups.
Descaling depends on the hardness of the
water, but also on the frequency of use.
- To descale follow the following method:
• Unscrew the grid from the head of the
machine and clean it (21).
• Dissolve a packet of KRUPS descaling
solution in 17 oz/510 ml of lukewarm water
and pour the whole batch into the empty
water container.
• Start the machine (4).
• Place a container, as large as possible,
beneath the auto cappuccino accessory.
As soon as the start/stop switch begins to
glow continuously, the machine is ready.
• Press the hot water button
through 1/3 of the liquid.
• Press the hot water button again
stop.
• Move the container under the brewing
head.
• Run the second third of the liquid
immediately by pressing the coffee button
(10) as many times as necessary.
• Stop the machine by pressing the start/stop
switch (4) and wait for 10 - 15 minutes to
allow the descaler to take effect.
• Next, start the machine again (4) and allow
the rest of the liquid to run through by
pressing the coffee button
many times as necessary.
• Then rinse with two water containers of
fresh water, clean the brewing head and
replace the grid on the head of the machine
(see section on Cleaning the Machine).
Espresso not hot
enough.
Coffee leaks
around the filter
holder.
(15), and run
(15) to
Pump is very noisy. No water in the
Water does not run No water in the
(10) as
through.
Troubleshooting
Problems
Probable causes Corrective actions
Cups, filter and
filter holder
are cold.
The filter holder
is not mounted
correctly or has
not been tightened
sufficiently.
There are coffee
grounds on the
edge of the filter.
The brewing head
gasket is dirty.
The brewing
head gasket
is defective.
Leaking through
paper pod.
water tank.
Water tank incor-
rectly mounted.
Coffee grounds too Use fresh coffee.
old or very dry
and the pump can-
not produce
pressure.
water tank.
Water tank incor-
rectly mounted.
The filter is blocked, Clean the filter and
the coffee grounds the grid on the
are too fine or
tamped down too
hard.
Preheat the
accessories (cups,
filter, filter holder)
See paragraph
«Preparing an
espresso».
See paragraph
«Preparing an
espresso».
Clean around the
filter and the
gasket.
Clean the gasket
with a damp cloth.
Contact an
approved Krups
service center.
Tear excess paper
from pod at
perforated edge.
Place the E.S.E. pod
with the RED
MARKING FACE
DOWN (bend the
paper corners
down). Take care to
put all the paper
inside the filter.
Fill the water tank.
Press firmly down
on the water tank.
Fill the water tank.
Press firmly down
on the water tank.
head.
See the paragraph
«Maintenance»
and try a coarser
coffee.
13
Publicité
Table des Matières
