Maintenance
Care of Your Garage Door Opener
MAINTENANCE SCHEDULE
Every Month
• Manually operate door. If it is unbalanced or binding, call a trained door
systems technician.
• Check to be sure door opens and closes fully. Adjust limits if necessary
(see Adjustment Step 1).
• Repeat the safety reversal test. Make any necessary adjustments (see
Adjustment Step 2).
Every Year
• Oil door rollers, bearings and hinges. The garage door opener does not
require additional lubrication. Do not grease the door tracks.
Every Two to Three Years
• Use a rag to wipe away the existing grease from the garage door opener
rail. Reapply a small layer of white lithium grease to the top and underside
of the rail surface where the trolley slides.
Smart LED Light
• Unplug the light before cleaning.
• Use a lightly dampened cloth for cleaning.
• DO NOT use liquid cleaners on the light lens.
THE REMOTE CONTROL BATTERY
The 3V CR2032 Lithium battery should produce power for up to 3 years. If
the battery is low, the remote control's LED will not flash when the button is
pressed.
To replace battery, pry open the case first in the middle (1), then at each side
(2 and 3) with the visor clip. Replace the batteries with only 3V CR2032 coin
cell batteries. Insert battery positive side up. Dispose of old batteries properly.
3V CR2032
3
3
1
1
2
2
35
To prevent possible SERIOUS
INJURY or DEATH:
• NEVER allow small children
near batteries.
• If battery is swallowed,
immediately notify doctor.
To reduce risk of fire, explosion or
chemical burn:
• Replace ONLY with 3V CR2032
coin batteries.
• DO NOT recharge,
disassemble, heat above
212° F (100° C) or incinerate.