Operation; Using Your Garage Door Opener - Chamberlain RJO70 Mode D'emploi

Operation

Using Your Garage Door Opener

FEATURES
Your garage door opener is equipped
with features to provide you with
greater control over your garage door
operation.
Alert2Close
The Alert2Close feature provides a
visual and an audible alert that an
unattended door is closing.
TIMER-TO-CLOSE (TTC)
The TTC feature automatically closes
the door after a specified time
period that can be adjusted using
a TTC enabled door control (Model
041A7327-1). Prior to and during the
door closing the garage door opener
lights will flash and the garage door
opener will beep. A Smart LED Light
must be installed to use TTC or myQ
to control the door.
myQ
®
myQ allows you to control your
®
garage door opener from your
mobile device or computer from
anywhere. myQ technology uses a
®
900Mhz signal to provide two way
communication between the garage
door opener and myQ
®
accessories. The garage door
opener has an internal gateway that
allows the garage door opener to
communicate directly with a home
Wi-Fi network and access your
®
myQ account.
®
MEMORY CAPACITY
SECURITY+ 2.0 ACCESSORIES
Remote Controls
Door Controls
Keyless Entries
myQ Acccessories
®
THE PROTECTOR SYSTEM
(SAFETY REVERSING SENSORS)
When properly connected and
aligned, the safety reversing sensors
will detect an obstruction in the path
of the infrared beam. If an obstruction
breaks the infrared beam while the
door is closing, the door will stop and
reverse to full open position, and the
opener lights will flash 10 times. If
the door is fully open, and the safety
reversing sensors are not installed, or
are misaligned, the door will not close
from a remote control. However, you
can close the door if you hold the
button on the door control or keyless
entry until the door is fully closed.
The safety reversing sensors do not
affect the opening cycle. For more
information see page 22.
®
ENERGY CONSERVATION
For energy efficiency the garage door
opener will enter sleep mode when
the door is fully closed. The sleep
mode shuts the garage door opener
down until activated. The sleep mode
is sequenced with the garage door
opener light; as the light turns off
the sensor LEDs will turn off and
enabled
whenever the garage door opener
lights turn on the sensor LEDs will
light. The garage door opener will
not go into the sleep mode until the
garage door opener has completed 5
cycles upon power up.
MEMORY CAPACITY
Up to 40
Up to 2 Smart Control Panels or 4 of any other
Security+ 2.0 door controls
Up to 4
Up to 16
28
LIGHTS
The garage door opener light will
turn on when the opener is initially
plugged in; power is restored after
interruption, or when the garage door
opener is activated. The light will turn
off automatically after 4-1/2 minutes.
Light Feature
The garage door opener is equipped
with an added feature; the lights
will turn on when someone enters
through the open garage door and the
safety reversing sensor infrared beam
is broken. For added control over the
light on your garage door opener, see
page 33.
USING YOUR GARAGE DOOR
OPENER
The garage door opener can be
activated through a wall-mounted
door control, remote control, wireless
keyless entry or myQ
®
When the door is closed and the
garage door opener is activated the
door will open. If the door senses an
obstruction or is interrupted while
opening the door will stop. When
the door is in any position other than
closed and the garage door opener
is activated the door will close. If
the garage door opener senses
an obstruction while closing, the
door will reverse. If the obstruction
interrupts the sensor beam the
garage door opener lights will blink
10 times. However, you can close the
door if you hold the button on the
door control or keyless entry until
the door is fully closed. The safety
reversing sensors do not affect the
opening cycle. The safety reversing
sensor must be connected and
aligned correctly before the garage
door opener will move in the down
direction.
BATTERY BACKUP
The battery backup system allows
access in and out of your garage,
even when the power is out. When
the garage door opener is operating
on battery power, the garage door
opener will run slower, the light will
not function, the Battery Status LED
will glow solid orange, and a beep
will sound approximately every 2
seconds.
accessory.