MRA 4025066143467 Instructions De Montage page 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA screen
4 Domed screw M5x16
4 Plastic washer 12 x 5mm
4 Rubber Nut M5
2 Holding plates
Fitting the screen to the motorcycle:
Place the motorcycle on a flat surface.
1.
Remove the two bolts (P2).
2.
Pull the headlamp mountings apart and bring the mounting plates into position
3.
(P3).
Reinsert the mounting bolts (P4).
4.
Insert the rubber nuts into the holes in the bracket.
5.
Bring the fairing screen into position on the bracket and secure it using the M5 x
6.
16 screws together with the plastic washers (P5).
Adjust the screen, making sure it is NOT in contact with the headlamp.
7.
When adjustment has been completed, retighten both of the mounting bolts.
8.
If desired, fit the protective edge strip on the rear exposed part of the screen,
9.
starting where the fairing overlaps and continuing to the opposite side. Any
remaining strip should be cut away.
It is also possible to push the clamping sleeves over the ends of the protective
10.
edge strip and lightly compress these using a pair of pliers to secure the edge
strip.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
Honda MSX125 2013-
Article No..
--- Allen key 3 & 5mm
10554
10635
10629
10898
3
Required tools