Parts Description; Functional Description - Makita DML813 Manuel D'instructions

PARTS DESCRIPTION

► Fig.1
1 Light head
4 Upper extension latch
7 Lower extension latch
10 Battery bay
13 Carrying handle
FUNCTIONAL
DESCRIPTION
CAUTION:
Always be sure that the appli-
ance is switched off and the battery cartridge is
removed before adjusting or checking function on
the appliance.
Installing or removing battery
cartridge
CAUTION:
Hold the appliance and the bat-
tery cartridge firmly when installing or removing
battery cartridge. Failure to hold the appliance and
the battery cartridge firmly may cause them to slip off
your hands and result in damage to the appliance and
battery cartridge and a personal injury.
CAUTION:
Be careful not to trap finger(s)
between the appliance and battery cartridge when
loading battery cartridge as well as between the
appliance and the battery cover when closing the
battery cover.
To install the battery cartridge, release the cover lock,
and open the battery cover.
► Fig.2: 1. Cover lock 2. Battery cover
To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Insert it all the way until it locks in place
with a little click.
Then close the battery cover.
► Fig.3: 1. Button 2. Battery cartridge
To remove the battery cartridge, slide it from the
appliance while sliding the button on the front of the
cartridge.
CAUTION:
Always install the battery cartridge
fully. If not, it may accidentally fall out of the appli-
ance, causing injury to you or someone around you.
CAUTION:
Do not install the battery cartridge
forcibly. If the cartridge does not slide in easily, it is
not being inserted correctly.
2 Lens
5 Lower extension pole
8 Power switch button
11 Shoulder belt hole
14 Tripod legs
Indicating the remaining battery
capacity
Only for battery cartridges with the indicator
► Fig.4: 1. Indicator lamps 2. Check button
Press the check button on the battery cartridge to indi-
cate the remaining battery capacity. The indicator lamps
light up for a few seconds.
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
NOTE: The first (far left) indicator lamp will blink when
the battery protection system works.
Appliance / battery protection
system
The appliance is equipped with the protection system.
This system automatically cuts off power to extend
appliance and battery life. The appliance will automati-
cally stop during operation if the appliance or battery is
placed under one of the following conditions.
Overdischarge protection
When the battery capacity becomes low, the LED lights
go out except a part of LEDs. Later, the system auto-
matically cuts off power. In this situation, remove the
battery cartridge from the appliance and charge it.
9 ENGLISH
3 Upper extension pole
6 Horizontal handle
9 Brightness change button
12 Tripod release button
15 Hole for fixing
Indicator lamps
Lighted Off
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
malfunctioned.