Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
To apply popcorn: ceiling texture, use one
of the largest openings (#1, 2, or 3) - Which
one will depend on the size of the acoustic
aggregate. The trigger setting should be fully
open. The air pressure should be 20–25 psi.
NOTE: The textures described above are
made using either a 3/8" or 1/2" I.D. hose. If
you are using a 1/4" I.D. hose, use greater
air pressures than specified.
Refilling WITHOUT Mud Pump
3
1
2
3
1
4
2
3
5
1
4
2
3
5
4
2
6
cap to remove.
com
com
1
3
1
2
5
7
Remove the tank from
your back and place on
4
8
a secure, level surface.
6
3
1
5
7
9
2
8
6
Flip the fill/spray toggle
switch to the FILL posi-
tion.
7
9
Pull upward on the
red lock release to
8
6
relieve the built up air
pressure. Ensure all
air pressure has been
released before moving
to the next step.
9
7
8
To remove the top cap,
begin by loosening
the top bolts 1-2 turns.
Next, while holding
the red lock release
up, turn the top cap
counter clockwise until
it stops. Lift up on the
3
5
7
4
2
6
5
7
4
8
6
9
release the air trapped between the piston
and the mud.
5
7
4
8
6
tight fit. Tighten top bolts as necessary.
Refilling WITH Mud Pump
1
2
3
from the pneumatic assembly.
1
2
air into the tank which will result in incon-
sistent textures.
9
Remove piston by
squeezing the gun trig-
8
ger and pulling upward
on the handle.
9
Next, fill the tank ¾ full
of drywall compound.
Insert piston into tank
and push down until
it is situated on top of
the mud. A slight twist-
ing or rocking motion
may be necessary to
9
Place top cap back
onto the tank by posi-
tioning over the top
bolts and twisting
clockwise. Once the
top cap is securely in
place, push down the
lock release to ensure a
3
5
7
Flip the fill/spray toggle
switch to the FILL posi-
4
6
tion. Ensure all air
pressure is released
from the tank before fill-
ing is started. You will
know this is done when
the air stops exhausting
5
7
4
8
Next, remove the cap
6
on the top of the gun
port plug by turning
counter clockwise.
Prime the pump until
the fill hose has filled
with mud. Failure to
do this step will force
9
8
9
5
Publicité
Table des Matières
