Side Panel - Yamaha RM-CR Manuel D'installation

6 [Dante/PoE] port
This is an RJ-45 port to which you can connect an LAN cable (CAT5e or higher) via an
IEEE802.3at compliant a PoE injector or the PoE network switch to a Dante unit such as
the RM-CG.
Notice : Do not connect any device here other than a Dante-compatible device or a
device (including a computer) that supports gigabit Ethernet.
: The maximum usable cable length is 100 meters.
: To prevent electromagnetic interference, use an STP (Shielded Twisted Pair)
cable.
7 Exhaust vent
This product is equipped with a cooling fan. Hot air is exhausted from this vent, so take
care that the vent is not blocked by any obstruction.

Side panel

This explanation uses an illustration of the left side as seen from the front.
1 Intake vent
Cooling air is taken in through this vent, so take care that the vent is not blocked by any
obstruction. You should also clean this vent periodically. If dust accumulates on this
vent, the temperature inside the unit might rise, causing the unit does not operate
normally.
2 Mounting accessory attachment holes
Use these when attaching the RM-MRK or RM-MTL mounting accessory.
For details on attaching the RM-MRK, refer to "INSTALLATION IN A RACK" (page. 15).
For details on attaching the RM-MTL, refer to "INSTALLATION ON A DESK" (page. 17).
1
RM-CR Installation Manual
2
13